Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

[NX8] Context help

Status
Not open for further replies.

cubalibre000

Mechanical
Joined
Jan 27, 2006
Messages
1,070
Location
IT
Hi,
when the command is show and I press F1 or Help-> On Context, the help start always at home and not in the relative command section.
solutions ?

Thank you...

Using NX 8 and TC8.3
 
I don't know, it works for me. As shown in your image, I opened the Edge Blend dialog, pressed 'F1' and got what you see in the attached image.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
 http://files.engineering.com/getfile.aspx?folder=93df6f6b-f77e-439d-a663-166fa52d3b18&file=NX_80_F1_Help.JPG
Hi John,
I've IE 9 and you IE 8.
Maybe it's this the problem.

Thank you...

Using NX 8 and TC8.3
 
I have the same problem. NX 8.0.2.2 and IE8
 
Then I suggest that both of you need to call GTAC and have them sort it out.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top