WHERE DO YOU FIND THE ABILITY TO ANIMATE SKETCH DIMENSIONS ON THE FLY IN NX9?? IN NX 7.5 THIS WAS AVAILABLE VIA A SLIDER BAR WHICH WAS INVOKED BY A (DOT DOT DOT ICON WHILE DIMENSIONING A SKETCH). IM NOT LOOKING FOR THE ANIMATE DIMENSION COMMAND WHICH IS AFTER THE DIMENSION WAS INSERTED.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX7.5 - NX9 SKETCH DIMENSION ANIMATE SLIDER BAR NOT IN NX9.5
- Thread starter manyman
- Start date
JohnRBaker
Mechanical
It's still there. While in the Sketcher, at the far left end of the Selection Bar there is a drop-down 'Menu' item. Just go to...
Menu -> Edit -> Sketch Parameters...
...select the Parameter of interest and you can then edit it using a 'slider bar' as you could in NX 7.5.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
Menu -> Edit -> Sketch Parameters...
...select the Parameter of interest and you can then edit it using a 'slider bar' as you could in NX 7.5.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status