Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX6 Edit Crosshatch Boundary

Status
Not open for further replies.

hurley710

Automotive
Joined
Feb 4, 2009
Messages
59
Location
US
Hello all,

Just upgraded to NX6 yesterday! Only thing I'm not seeing is the icon to edit crosshatch boundary. In the past, If i needed to place a dimension or ID symbol over crosshatching, I could then edit the boundary and add the dim/symbol and it would just x-hatch around it rather than through it. The only way I'm seeing this can be done now is by right-clicking on the x-hatch and selecting Edit. I'm not a fan. Anyone know if an icon still exists to do this? Thanks in advance.
 
There is no longer an explicit 'Edit Crosshatch' icon, but rather one labeled 'Edit Annotation' on the Drafting Edit toolbar which is a general purpose tool allowing you to select and edit any Drafting annotation object. Either select the crosshatch object first and then the 'Edit Annotation' icon, or select the icon first and then the crosshatching.

BTW, if you had used the Command Finder and typed in 'crosshatch', 'Edit Annotation' would been one of the hits.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

To an Engineer, the glass is twice as big as it needs to be.
 
Thanks for the quick response, John!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top