To clarify this a little bit...
Our parts are created with Solid Edge in aircraft coordinate system. To measure them with our Faro arm we need a coordinate system on the part. In the past we have exported an iges from Edge and created the coordinate system with Solid Works. We are transitioning to NX and need to be able to do this with NX instead of Solid Works.
When I open one of our Edge files in NX the WCS is aligned with the aircraft coordinate system. I can move the WCS to where I need it, but when I export the iges file the original aircraft coordinate system is retained. The only workaround I have found is moving the part to where I need it.
This is a difficult process when the part needs to be moved and rotated in X, Y and Z, and is too time consuming to be acceptable for usage on a daily basis.