Hello everyone,
I'd like to make an application using Block UI Styler, where the user can move an object by specifyng a new point using the sketch from the supersection-block.
The object would be moved then to the new specified point, which was coincidentally contrained to a line.
I have 2 main problems here:
- the recorded journal for the sketch commands returns a few objects and i dont know how to get the exact information of my point.
- I can place a callback code for when the supersection button is used, but in this case I need the properties of the block/the callback code when the user is done with with the sketch. Are there any examples for using sketching in Block UI Styler?
I am quite new to NXOpen and programming in general. Any suggestions and comments are welcome. Thank you
I'd like to make an application using Block UI Styler, where the user can move an object by specifyng a new point using the sketch from the supersection-block.
The object would be moved then to the new specified point, which was coincidentally contrained to a line.
I have 2 main problems here:
- the recorded journal for the sketch commands returns a few objects and i dont know how to get the exact information of my point.
- I can place a callback code for when the supersection button is used, but in this case I need the properties of the block/the callback code when the user is done with with the sketch. Are there any examples for using sketching in Block UI Styler?
I am quite new to NXOpen and programming in general. Any suggestions and comments are welcome. Thank you