Hi,
Let's say I create a Block.
Then I apply Pull Face (Synchronous Modeling) to one of its faces.
At the end, I want to create a Draft Body, using the Parting Line of the "Pull Face" as reference.
Question: Is this "Parting Line" selectable?
I know I could use different options but I am interested in this particular topic (Parting Line management)
Thanks!
MZ7DYJ
Let's say I create a Block.
Then I apply Pull Face (Synchronous Modeling) to one of its faces.
At the end, I want to create a Draft Body, using the Parting Line of the "Pull Face" as reference.
Question: Is this "Parting Line" selectable?
I know I could use different options but I am interested in this particular topic (Parting Line management)
Thanks!
MZ7DYJ