Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX "Attempt to save bad pointer" error

Status
Not open for further replies.
jut07

jut07

Mechanical
Jun 9, 2008
17
thread561-334899

Hi All,

I don't post much, but this error has had me pulling hair out. One solution I have found is to make sure the assembly structure is good in TC and then I found I had to manage pending components in the assembly menu. These 2 steps seemed to clear everything up for me. I thought I would share - I hope you find it useful.



 
Status
Not open for further replies.

Similar threads

CAD2015
  • Question
NX 2212: Subtraction error....... 4
Replies
11
Views
809
CAD2015
CAD2015
Asieros
  • Locked
  • Question
Siemens NX Drafting - Reset the "Border to Arrow Distance"
Replies
0
Views
623
Asieros
Asieros
H
  • Question
NX Flow: Results generator error for Tecplot results
Replies
0
Views
2K
Herwig
H
MANox
  • Locked
  • Question
Change tabs bar posiotion to "centered"
Replies
2
Views
355
MANox
MANox
Anton Liubimov
  • Locked
  • Question
NxOpen, How to programmatically open a dialog box "Extrude"
Replies
2
Views
667
Anton Liubimov
Anton Liubimov

Part and Inventory Search

Sponsor

Back
Top Bottom