Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX hole table Negative values

Status
Not open for further replies.
donrafa7

donrafa7

Mechanical
Joined
Mar 13, 2015
Messages
13
Location
US
Is it possible to have an NX hole table show Negative values on the drawing. Ordinate is in center of part so i have some holes above and some below. Thanks
 
Sort by date Sort by votes
change the positive direction in the settings for the hole table to 'user defined' (see image below).

2018-07-13_9-43-45_iwzotf.png




Anthony Galante
Senior Support Engineer


NX3 to NX11 with almost every MR (24versions)
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

shightower
  • Locked
  • Question Question
Countersink on both sides of hole in NX?
Replies
3
Views
2K
Bleaker
Bleaker
johnny777886
  • Locked
  • Question Question
NX2206 Hole Table Numbers Reset
Replies
0
Views
403
johnny777886
johnny777886
G
  • Question Question
NX Journal
Replies
15
Views
28K
Toost
Toost
CAD2015
  • Question Question
NX X.....................
Replies
9
Views
2K
DrPriest
DrPriest
jmarkus
  • Question Question
NX Journal - Sketch Selection Subroutine
Replies
3
Views
7K
jmarkus
jmarkus

Part and Inventory Search

Sponsor

Back
Top