Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX ERROR'S 1

Status
Not open for further replies.

SRamya

Mechanical
Jan 20, 2016
2
Hi All ,

I have started this thread to post about the error's that we come across in NX & seeking suggestions/ solutions in accordance with it.

Attached herewith are few of the snapshots of the error's that I come across very often.

can anyone help me or suggest as to how to tackle these errors going forward.

It's really getting difficult for me to proceed further ,

TIA [smile]

 
 http://files.engineering.com/getfile.aspx?folder=e4fcd44c-1566-4685-a053-cda8ce5b89b8&file=UG1.PNG
Replies continue below

Recommended for you

No Clue... Looked on Siemens GTAC Support site and could find only one posting from 1998 with the same error message...
I would suggest to call Gtac and raise a ticket for it....

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 
do you get this error often ?
On different files or a specific one ?

I don't recall that I have ever seen it in my 25 years.

I think it is a Parasolid error message, and I believe that CFI is Common File Interface, but no more.

As Ronald says, call GTAC.


Regards,
Tomas
 
Thanks for the suggestion.

I came across these kindo errors only for some specific files( too huge one's).
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor