NX ERROR'S 1

[SRamya]

Hi All ,

I have started this thread to post about the error's that we come across in NX & seeking suggestions/ solutions in accordance with it.

Attached herewith are few of the snapshots of the error's that I come across very often.

can anyone help me or suggest as to how to tackle these errors going forward.

It's really getting difficult for me to proceed further ,

TIA

 

[NutAce]

No Clue... Looked on Siemens GTAC Support site and could find only one posting from 1998 with the same error message...
I would suggest to call Gtac and raise a ticket for it....

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 

[Toost]

do you get this error often ?
On different files or a specific one ?

I don't recall that I have ever seen it in my 25 years.

I think it is a Parasolid error message, and I believe that CFI is Common File Interface, but no more.

As Ronald says, call GTAC.


Regards,
Tomas

 

[SRamya]

Thanks for the suggestion.

I came across these kindo errors only for some specific files( too huge one's).