Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Nx Cam - inverse feed rate 1
- Thread starter ma1ster
- Start date
-
1
- #2
In the operation - Machine Control - Start of Path Events - add Set Modes - Feed Rate Mode - set it to Inverse. At the End of path events set feed rate back to IPM or whatever you need. In post builder in Machine Control - Feedrates - FRN Mode - set G93 and Format max = 999999.999 and min = .001.
Hope this helps,
Rick
Win7 64 bit w/NX9.0.3.4 MP9 and NX10.0.2
Vericut 7.4
Hope this helps,
Rick
Win7 64 bit w/NX9.0.3.4 MP9 and NX10.0.2
Vericut 7.4
- Thread starter
- #3
- Status
