NX Assembly Problem 2

[aeromb1985]

Dear All
I am using NX 11 on 64 bit Microsoft windows 10.
I modeled an impeller in NX model section and saved it as prt file. After opening the part in assembly section, all eliminated elements are visible as shown in attachment.
It there any solution?
Thanks

 

[SDETERS]

Check you reference sets, you probably have extra geometry in the model reference set, The reference set to check for geometry would be in your part, also check to see what reference set your assembly is using.

 

[cowski]

I think SDETERS has it right. Just to add on, note that with the default settings, NX will create a "MODEL" reference set and automatically add any solid and sheet bodies as you create them in the file. It looks like an extracted body was added to your reference set, causing it to show up in the assembly.

www.nxjournaling.com

 

[aeromb1985]

Dear All
Thank you for your replies. It is solved.