Gregalex
Mechanical
- Jun 23, 2014
- 3
Hi guys,
does any one know how to tell NX UG 8.5 to show all parallel faces and orthogonal ones?
Greg
does any one know how to tell NX UG 8.5 to show all parallel faces and orthogonal ones?
Greg
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX 8.5
- Thread starter Gregalex
- Start date
- Status
JohnRBaker
Mechanical
In what context?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
Gregalex
Mechanical
- Jun 23, 2014
- 3
Hi John,
oh yeh, Im sorry I forget to tell that Im talking about faces while assembling.
I have a huge assembled part and I would like to know which Faces are parallel to which ones. Cause some of them are not even if it look like they are parallel to each other.
oh yeh, Im sorry I forget to tell that Im talking about faces while assembling.
I have a huge assembled part and I would like to know which Faces are parallel to which ones. Cause some of them are not even if it look like they are parallel to each other.
- Status
