Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 8.5 Sketch constraint settings ?

Status
Not open for further replies.

dabiz7

Automotive
Joined
Nov 30, 2012
Messages
47
Location
US
Used NX 8 for a while
Updated to 8.5, can't find the setting that allows me to constrain my sketch geometry to other edges of previously created objects?
I have inferred constraints and dimensions turned on, but it doesn't allow me to pick any previously created edges or geometry to constrain my current active sketch to
 
Check the "selection scope" dropdown, it may be set to "active sketch" instead of "entire part" (or something along those lines).

www.nxjournaling.com
 
I am an idiot.
That was exactly correct !!!
Thank you !!!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top