Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
nx 8.5 post builder
- Thread starter jrrubiojr
- Start date
- Thread starter
- #3
Mark thank you for replying to my issue. I am new at this, so bear with me. I went into N/C Data Definitions, block tab, circular_move. I scrolled down and couldn't see what you were referring to. This is what I am seeing. The version I'm using is 8.5. Thank you in advance.
Instead of the block definitions, you need to look at which blocks are output with each move.
You can find this in Program & Tool Path, Program, Motion, Circular Move.
If you can;t attend the Post Building class, I recommend you at least go through some of the tech tip videos that we provide.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
You can find this in Program & Tool Path, Program, Motion, Circular Move.
If you can;t attend the Post Building class, I recommend you at least go through some of the tech tip videos that we provide.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question