Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

nx 8.5 pmi's in view from part.

Status
Not open for further replies.

helperug

New member
Joined
Dec 10, 2011
Messages
144
Location
DE
I want to do a view from part in a assembley drawing, using a view from one of its components containing PMIs.
I found a workaround by switching the ANT Icon with a sheet from the component to reference set entire part.
Is there a setting to force view from part to refence set entire part, cause of the PMIs?

sorry new in NX
regards
Erwin
 
It sounds as though you just need to make the PMI visible in the view. In Model Views in the Part Navigator the PMI will be listed under the view where it was created. To show in other views right click on the PMI and select Display/In Views, then select the required view.
In the drawing you will also need edit the View Style setting to inherit the PMI from the model (Inherit PMI tab).

Mike
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top