KennethAndersen
Mechanical
Hello
How can it be that my party list is divided between 34 and 35?
And how do I get it together?
How can it be that my party list is divided between 34 and 35?
And how do I get it together?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX 7,5 Part List
- Thread starter KennethAndersen
- Start date
- Status
Not Sure that I completly understand what you are asking, but my guess would be that there was an extra row inserted for some reason. I am guessing that you are woking in drafting and trying to get your BOM on to a sheet correct. If it is that there is just an axtra row in the Parts List, just try to highlight the row, by hovering over the outer edge and then you should be able to Delete that row.
Right click on your parts list and choose Style; switch to the Sections tab and change the value of Maximum Height to a larger value (but smaller than the height of your drawing sheet).
www.nxjournaling.com
www.nxjournaling.com
- Thread starter
- #4
KennethAndersen
Mechanical
Thanks.
It works now
why do () brackets in the sells?
It works now
why do () brackets in the sells?
The brackets in the cells is a result of the "highlight manual text" option; to get rid of the brackets, turn that option off.
www.nxjournaling.com
www.nxjournaling.com
- Status