Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX 6 Drawing Formats
- Thread starter iancopt
- Start date
JohnRBaker
Mechanical
Attached is sample drawing template which I use for my demos. Note that it uses a 'Custom Symbol' for the actual 'form'.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
JohnRBaker
Mechanical
Sorry, I don't. I just figured it out for myself as I went along, but then I've been using Unigraphics/NX for over 33 years so after awhile you lose track of exactly when and where you discovered how something worked. And since once you know how something works, you rarely go back and look to see if someone else may have written it down somewhere.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #5
- Status