Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 6.0 Weld symbols

Status
Not open for further replies.

TomLoughlin

Military
Joined
Mar 14, 2014
Messages
18
Location
GB
Morning Chaps,

Just a quick question I hope:

I have put in a weld symbol onto a drawing, and it doesn't look right to me (or the checker). My issue is with the flat/convex symbol above the weld type - it looks too far away/misaligned.

It isn't a show stopper, but thought I would ask the question on here.

See attached pic or my drawing:

getfile.aspx


And pic of what I am aiming to achieve from BS22553:1994:

getfile.aspx


Cheers

Tom
 
This issue appears to have been addressed with NX 7.5.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Ah right, thanks John.

Will have to tell the checker that's just the way it is for now then.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top