Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 1953: How to 'create' Extreme Points?

Status
Not open for further replies.

SMO

Mechanical
Joined
Nov 11, 2016
Messages
73
Location
US
I'm not seeing how I can set the Output Geometry in the newer Measure tool that would allow me to 'create' an Extreme point. This was possible in NX 12 using the standalone Extreme Point Measurement tool, but that's now pulled into the Measure tool. Anyone know about this?

Regards,
SMO (NX11)
 
I think I figured it out. Not only does the Extreme Point option have to be Checked in the Measurement Preferences, but Other has to be selected as well as Extreme in the Results Filter. Then when you select Associative and open the flyout menu on screen, you get the option to create geometry. Not a huge fan of this, but I'm glad it works!

Regards,
SMO (NX11)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top