Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Number of lane in curved Ramp with varying width - AASHTO LRFD 1

Status
Not open for further replies.

Nayan67

Civil/Environmental
Feb 8, 2023
30
Hello everyone,

I am analyzing a curved ramp with three spans (36m, 45m, and 30m). The first two spans have a carriage width of more than 11.0 meters. However, between the second and third spans, there is a portion where the carriage width is less than 10.5 meters. In this regard, how many lanes should there be? Should I use three lanes (since 11/3.65 > 3.0) in the portions where the carriage width is greater than 11.0 meters and then reduce to two lanes where the ratio of carriage width to 3.65 is less than 3.0?

 
Replies continue below

Recommended for you

I would say that since it's not possible to have 3 lanes all the way across the bridge, you could analyze it as a 2 lane bridge.

The only place where I think it would matter is for the total live load on the substructures, so if you wanted to consider 3 lanes for that calculation on the substructures supporting the spans where it's wide enough for 3 lanes, you could. With the Rigid Override considered, the scenario with 3 lanes loaded is unlikely to produce a critical load combination, though.
 
BridgeSmith, Thank you so much for your insights.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor