Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NPTF Question

Status
Not open for further replies.
JEREMER

JEREMER

Mechanical
Joined
Nov 29, 2005
Messages
9
Location
US
I was just trying to use a CLS PEM in the face of an enclosure (16ga) to mount a hose barb in. Is there any way I can match up the thread? I believe it's a 1/8 NPTF (but I'm not sure). I just know that the hose barb is used on a 1/4" tube and the ID of the barb measures to .100 exactly. If someone could help me out on this I would greatly appriciate it.

Thanks again,
Jr-
 
Status
Not open for further replies.

Similar threads

N
  • Question Question
Question on V-Loops
Replies
6
Views
15K
KevinNZ
KevinNZ
IdanPV
  • Question Question
Bentley Autopipe Question
Replies
4
Views
4K
IdanPV
IdanPV
P
  • Question Question
Thick Walled Cylinder Question
Replies
6
Views
5K
PipesAndStuff
P
F
  • Locked
  • Question Question
Water siphon question
Replies
12
Views
6K
georgeverghese
georgeverghese
Ccorvera
  • Locked
  • Question Question
CAESAR SIF Question
Replies
3
Views
2K
Ccorvera
Ccorvera

Part and Inventory Search

Sponsor

Back
Top