Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NPTF Question

Status
Not open for further replies.
JEREMER

JEREMER

Mechanical
Nov 29, 2005
9
I was just trying to use a CLS PEM in the face of an enclosure (16ga) to mount a hose barb in. Is there any way I can match up the thread? I believe it's a 1/8 NPTF (but I'm not sure). I just know that the hose barb is used on a 1/4" tube and the ID of the barb measures to .100 exactly. If someone could help me out on this I would greatly appriciate it.

Thanks again,
Jr-
 
Status
Not open for further replies.

Similar threads

IdanPV
  • Question
Bentley Autopipe Question 1
Replies
4
Views
4K
IdanPV
IdanPV
P
  • Question
Thick Walled Cylinder Question
Replies
6
Views
5K
PipesAndStuff
P
F
  • Question
Water siphon question 2
Replies
12
Views
6K
georgeverghese
georgeverghese
Ccorvera
  • Locked
  • Question
CAESAR SIF Question
Replies
3
Views
1K
Ccorvera
Ccorvera
B
  • Question
Question about chiller flow control with bypass
Replies
7
Views
3K
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top Bottom