Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NPT threads

Status
Not open for further replies.
whattosay

whattosay

Industrial
Joined
Oct 11, 2005
Messages
1
Location
DK
Hey - I need a standard for 1/2" NPT-threads. Where do i find that?
 
Sort by date Sort by votes
Have you got access to a copy of Machinery's Handbook? If so, there's a pretty good section devoted to pipe threads.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Josh Blank
  • Locked
  • Question Question
Using an O-Ring to seal on an NPT lead chamfer - Design Improvement Ideas
Replies
10
Views
2K
Tmoose
Tmoose
65CCJ
  • Locked
  • Question Question
Thread Form isn't correct but gages OK for 1"NPT Male Thread - Is the picture grounds for scrap
Replies
8
Views
700
65CCJ
65CCJ
R1chJC
  • Locked
  • Question Question
Threads passed inspection but wont assemble.
Replies
11
Views
512
tbuelna
tbuelna
UCengno1
  • Locked
  • Question Question
Inspection of NC machined NPT
Replies
1
Views
184
Duwe6
Duwe6
moleroal
  • Locked
  • Question Question
more than 7"threads verification
Replies
4
Views
168
TVP
TVP

Part and Inventory Search

Sponsor

Back
Top