Nov 17, 2010 #1 tango1231 Mechanical Apr 20, 2009 1 is there an asme code that identifies what is allowed for nozzle protrusion?
Nov 17, 2010 #3 pennpiper Mechanical Dec 9, 2005 1,687 Common sense is the best guidance available. Upvote 0 Downvote
Nov 22, 2010 #4 AC2Q Nuclear Nov 22, 2010 1 Unless your application is such that a certain amount of protrusion is needed, (to reduce impingement, for a dip tube, etc) then there is nothing to be gained by going beyond the limits of reinforcement. Upvote 0 Downvote
Unless your application is such that a certain amount of protrusion is needed, (to reduce impingement, for a dip tube, etc) then there is nothing to be gained by going beyond the limits of reinforcement.
Nov 22, 2010 #5 SnTMan Mechanical Jan 22, 2005 6,824 A good practice is to provide enough projection to allow removal of flange studs out the backside, over the insulation, if any. Regards, Mike Upvote 0 Downvote
A good practice is to provide enough projection to allow removal of flange studs out the backside, over the insulation, if any. Regards, Mike
