Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

nozzle or half coupling according ASME

Status
Not open for further replies.
ranas1

ranas1

Mechanical
Joined
May 31, 2011
Messages
16
Location
MX
Hi, im new in this forum, i would like to know if someone to know if there is a standard ASME for manufacture nozzle and half coupling used in compress tank ???

I have been looking in ASME section VIII div -1 but i have not found a standard for that.

Best regard
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Whin
  • Question Question
Nozzle internal design pressure.
Replies
1
Views
390
HTURKAK
HTURKAK
Andres Romero
  • Question Question
Required thickness according to API 620
Replies
1
Views
2K
JStephen
JStephen
D
  • Locked
  • Question Question
Fully supported flanged tank bottom according to EN 14015
Replies
7
Views
3K
LittleInch
LittleInch
Andres Romero
  • Locked
  • Question Question
doubt with background repair according to API 653
Replies
6
Views
967
Andres Romero
Andres Romero
jimmyhutmacher
  • Locked
  • Question Question
Half above / half below floor drain
Replies
5
Views
706
Dhurjati Sen
Dhurjati Sen

Part and Inventory Search

Sponsor

Back
Top