Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
nozzle and Reinforcement Pad acceptance criteria
- Thread starter sokapo
- Start date
gr2vessels
Mechanical
sokapo,
If you are checking an existing tank, you have to refer to the design code used for that tank. You have to inspect and measure actual thicknesses, refer to the general API 653 requirements.
If you intend to modify an existing tank (adding nozzles), then again refer to API Std 653, Clause 9.8 and have handy the API 650.
cheers,
gr2vessels
If you are checking an existing tank, you have to refer to the design code used for that tank. You have to inspect and measure actual thicknesses, refer to the general API 653 requirements.
If you intend to modify an existing tank (adding nozzles), then again refer to API Std 653, Clause 9.8 and have handy the API 650.
cheers,
gr2vessels
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question