thesiswork
Student
Hello,
Is it always necessary to use normal mode analysis to figure out true sensor location?
Is it always necessary to use normal mode analysis to figure out true sensor location?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Normal Mode Analysis 1
- Thread starter thesiswork
- Start date
- Status
-
1
- #2
- Thread starter
- #3
thesiswork
Student
Hello,
I am doing a project and recently we did some testing. Since we did not had any prior knowledge how the test was setup, normal mode analysis was not simulated. Is it the correct way to do testing or you can skip the mode analysis?
I am doing a project and recently we did some testing. Since we did not had any prior knowledge how the test was setup, normal mode analysis was not simulated. Is it the correct way to do testing or you can skip the mode analysis?
GregLocock
Automotive
Still not making much sense. Are you worried that your sensors might be on the nodes of a mode shape and won't pick them up?
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376
- Status
Similar threads
- Question
