Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Non-Standard/Customised Flange MAWP 2
- Thread starter Karthik P
- Start date
-
1
- #2
Karthik P, the usual approach is to design the flange, then recursively increase the design pressure, holding all else constant, until the flange fails in some way. The highest pressure not resulting in failure is the MAWP. Best done by computer methods, even a spreadsheet.
Regards,
Mike
The problem with sloppy work is that the supply FAR EXCEEDS the demand
Regards,
Mike
The problem with sloppy work is that the supply FAR EXCEEDS the demand
-
1
- #4
LittleInch
Petroleum
Make one, pressure test it to destruction then divide by 3?
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
- Status
Similar threads
- Locked
- Question
- Locked
- Solved