Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Non-reusable clutch hubs?

Status
Not open for further replies.

geesamand

Mechanical
Joined
Jun 2, 2006
Messages
688
Location
US
I was skimming over a factory service manual for a Nissan 350Z manual transmission, when I noticed that Nissan recommended replacement of any clutch hub/sleeve pair removed from the tranny. I found this rather curious, and frightening from a cost standpoint.

Is it the splined fit b/t the hub and shaft, or something else that makes a used clutch hub/sleeve set unsuitable?

Dave
 
Maybe they're assuming the clutch dogs must be shot if you're in there, and you might as well replace them while you have them out.

It may be entirely conjectural; the factory probably has much less experience with really used transmissions than you do.





Mike Halloran
Pembroke Pines, FL, USA
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top