Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
No display after commands.
- Thread starter proeddie
- Start date
Are you talking about your dialog boxes?
If you are, there is a simple fix...
If you are not getting a dialog box when you want to plot type in "CMDDIA" at the command line. If the value is set to 0 (zero) re-set it to 1 (by typing in 1 at the promt)and the dialog box should return.
If you are not getting a dialog box when you want to save as or open a file, type "FILEDIA" at the command line. If the value is set to 0 (zero) re-set it to 1 (by typing in 1 at the promt) and the dialog box should return.
If this isn't what you wanted for information, please send more specifics on the problem and hopefully someone will ba able to help.
If you are, there is a simple fix...
If you are not getting a dialog box when you want to plot type in "CMDDIA" at the command line. If the value is set to 0 (zero) re-set it to 1 (by typing in 1 at the promt)and the dialog box should return.
If you are not getting a dialog box when you want to save as or open a file, type "FILEDIA" at the command line. If the value is set to 0 (zero) re-set it to 1 (by typing in 1 at the promt) and the dialog box should return.
If this isn't what you wanted for information, please send more specifics on the problem and hopefully someone will ba able to help.
- Status
Similar threads
- Locked
- Question
- Locked
- Question