ytyyutianyun
Mechanical
- May 10, 2012
- 1
I can only use the command,How can I use the 3d link180 for the 2d truss in gui
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
No 2d spar for truss in ansys 13
- Thread starter ytyyutianyun
- Start date
- Status
Similar threads
- Question
- Locked
- Question