I need some information on minimum feeder speed requirements for coal mills. Right now the minimum feeder speed on the mills is 20%. I would like to drop that to 15%. Could this create any problems when starting, or stopping a mill under normal operation? I could not find anything specific in NFPA 85.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NFPA 85 Boiler and Cumbustion System Hazards Code question.
- Thread starter tsfly
- Start date
Similar threads
- Locked
- Question
