Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

New to the Forum: Hope yall can help. RE: Tolerances for Risers, Ductile Iron, Fire Protection

Status
Not open for further replies.
Tuskasaurus

Tuskasaurus

Industrial
Joined
Jul 17, 2012
Messages
2
Location
US
Can anyone direct me to a publication that gives allowable (plumb) tolerances for (vertical) risers for ductile iron.

I would greatly appreciate any and all help as I have exhausted my capabilities of 'net research!

Thanks,

Tusk
 
Status
Not open for further replies.

Similar threads

G
  • Locked
When I looked at the specification ASTM C33 I did not find the specification limits for the 1/2-inch sieve as mentioned in the
Replies
0
Views
1K
GHADA ALQARESH
G
Truds
  • Locked
  • Question Question
Can anyway advise what the differen
Replies
2
Views
930
Truds
Truds
MujtabaQA
  • Locked
  • Question Question
Who can explain about Thin-wall pipe as per ASTM standard
Replies
6
Views
2K
EdStainless
EdStainless
qcrobert
  • Locked
  • Question Question
How can steel manufacturer chemical composition differ from ASTM/ASME chem comp?
Replies
5
Views
1K
qcrobert
qcrobert
Muza33
  • Locked
  • Question Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
740
Muza33
Muza33

Part and Inventory Search

Sponsor

Back
Top