Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Need INFO. on ANSI B16.5
- Thread starter producer
- Start date
It can be machined from hot rolled bar but the axis of the hub of finished flange shall be parallel to the long axis of the original bar.
The ring formed from plate shall have original plate surfaces (lamination direction) perpendicular to the axis of the finished flange.
The joint between ring and hub shall be butt welded and controlled according to the code.
The ring formed from plate shall have original plate surfaces (lamination direction) perpendicular to the axis of the finished flange.
The joint between ring and hub shall be butt welded and controlled according to the code.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question