hardwarefpl
Industrial
Iam working on some door hardware. I need a spur gear no bigger than .500 dia o/d to drive a rack .400 with a 90 degree turn of the spur gear.
Thanks!!!!
Thanks!!!!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Need help spur & rack gear
- Thread starter hardwarefpl
- Start date
- Status
diamondjim
Mechanical
Your pitch diameter would have to be approx
.5200 for 90 degrees to move the rack .4000
.5200 for 90 degrees to move the rack .4000
- Status
Similar threads
