Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need help in the identification of a sleeve bearing

Status
Not open for further replies.

CR100

New member
Sep 1, 2009
69
I am looking for the manufacturer of this sleeve bearing. Unfortunately I only have the company logo. Can anyone be of help?

Thanks



 
Replies continue below

Recommended for you

This is the sort of part that I would expect to be manufactured by the manufacturer of the machine. Who built the machine that this came out of? I am more interested in the part number than the small stamp next to it. You believe that this stamp is a manufacturer’s logo. Why do you assume that? The part number is consistent with some parts that I stock from Dresser-Rand. But, I could not see the full part number in the provided picture.

Johnny Pellin
 
It is split yes, and has inner liner of ptfe.

 
you can get PN. from equipment manual and purchase bearing from equipment manufactor.
 
You should contact Beemer Precision at the link below. Beemer has identified from descriptions or partial numbers many bearings for us even some that were 50 years old. i hope they still have the technical reps they did have.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor