Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need gearing suggestions for winch

Status
Not open for further replies.

tdw

Mechanical
Joined
Aug 6, 2002
Messages
23
Location
US
I'm building a winch system with a 16" dia. drum (single wrap). The winch is required to lift a 3600# load at 20 FPM. The maximum speed of the winch is 105 FPM.
My Hydraulic motor runs at 660 RPM (max)and requires a minimum of 7:1 gear ratio to achieve the specified torque.
I was going to use 5DP spur gears, 2" wide, (10T to 140T) to drive the drum, but now I'm worried that they won't be able to handle the torque.
Any suggestions?
 
I hope you realize that a 140 Tooth 5 DP spur gear has a 28" pitch diameter. That makes a big housing. Have you considered a double reduction or a worm and worm gear drive?
 
Shopguy,
You're right, the large gear was really 70T not 140T.
I've decided to go witha Fairfield W2B3 torque hub. It's much more expensive but more reliable in the long run.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top