Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need advice on assembling rubber grommet to cylinder

Status
Not open for further replies.

Slipree

Mechanical
Joined
Jan 7, 2005
Messages
1
Location
US
I am new to Inventor and would like some advice on an easy way to set up a rubber grommet to assemble to the wall of a cylinder. These thin walled cylinders come in a variety of diameters and the holes vary in location. The flexible grommets must take on the radius of the cylinder that they are assembled to. I couldn't find anything similar to this in the documentation that I have read so far. I would appreciate any help that you could provide.
Slipree
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top