Need Acu-rite Millpower Post Processor

[Mr.Evenflo]

Hello


We recently purchased the manufacturing add-on for Pro-E/wildfire 3 and have hit a wall with getting one of the stock G-Post processors to work with our Acu-rite Millpower controller. We are trying to use the stock UNCX01.P14 (Fadal VMC 15-CNC 32MP). We discovered after sending the code to the Acu-rite software engineers that the I and J values were missing from some ofthe G2-G3 arc movements. They said the post you are trying to use must assume that the controller will hold the last modal I and J from the last arcand carry the values over to thefollowing arcs. They stated that the Millpower controller will not hold previous I and J for following arcs and that we must SPECIFY on every G2 G3 arc. Can someone assist us in adding this using the G-Post processor modification program in wildfire 3/manufacturing? Any help would be FANTASTIC!!!!


Thanks guys!!!!


Mr.Evenflo


David.Strait@evenflo.com

 

[wsylvester]

88 00 Motion registers XYZIJKABC are modal.. (default)
01 Motion registers XYZIJKABC are non-modal.
here's what you are needing to find..from thegpost document

 

[indigo2]

David

 

[Mr.Evenflo]

Thanks Tsl,





I'll try and modify them in the program, if I run into any problems I'll let you know. I thought it might be something simple like this, I just didn't know where to look. Beats paying PTC more money for a "custom" post like they want us to do.


Thanks for your help!!!


David

 

[Don.Rhea]

Mr Evenflo,


If you will open the opt file generator, go to the advanced tab at the


bottom, then pick plable, then pick 81-90, then look at 88 this should solve your


problem

 

[Mr.Evenflo]

Thanks guys for your help! the suggestions worked. I have applied both to the post and the machine runs all the way through now.


Thanks Again!


Mr. Evenflo