Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NDT of Bonded Seals

Status
Not open for further replies.

AlexEss

Automotive
Joined
Dec 23, 2015
Messages
28
Location
IT
Hi All

We manufacture a range of Bonded Seals - a rubber sealing ring in bonded to the inside diameter of metal washers.
These are small - typically 3/4" to 1.5" diameter and 1/8" thick.

I'm seeking a non-contact, non destructive test method to detect disband or bond failure over small areas of the rubber/metal interface. I'm thinking x-ray or thermal wave, along those lines.

Does the forum have any suggestions or experience along those lines please ?

Thanks in advance for any reply.

Cheers

Alex
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top