Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NDSURF not working?

Status
Not open for further replies.
Hup

Hup

Mechanical
Jan 13, 2006
36
It seems to me that this command does not work properly. It is documented and should create SURF151/152 elements and connect them to closest nodes of FLUID161. It doesn't recognize the first argument - nodal component.

Has anybody met this problem? Thx, Tom
 
Status
Not open for further replies.

Similar threads

T
  • Question
Accessing Named Selections of Contact Surfaces via CMSEL After Applying Condensed Geometry Not Possible
Replies
0
Views
2K
TOM1345
T
H
  • Locked
  • Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
andradesilva
  • Locked
  • Question
I am not able to see fracture of the specimen in explicit dynamics in ANSYS Workbench 2023 R1
Replies
0
Views
299
andradesilva
andradesilva
rc0213
  • Locked
  • Question
Ansys Beginner - Not FEA Beginner
Replies
2
Views
198
ALANIT
ALANIT
leo0012
  • Locked
  • Question
Simulation of a screw does not converge in Ansys
Replies
2
Views
233
SPDL310
SPDL310

Part and Inventory Search

Sponsor

Back
Top Bottom