Nastran PBEAM entry OFFSET

[glenn11897]

I'm trying to model a tapered bar:

| | | | \_________________
| |
| |
| |
|__________________________|
XXXXXXXXXXXXXXXXXXXXXXXXXXXX

I'm using PBEAM card but I need to represent the offset. The bar element is on the "X" as shown. (Note: This is part of a bigger FEM) I have all the properties calculated but I don't know how to represent the offset? Without the offset, I believe the element would look like this:


| | | | \_________________
|X |
| XXXXXXXXXXXXXXXXXXXXXXXX|
| |
|__________________________|

And not produce the actual bending moments.

Thanks in advance...