Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NASM 1352 finishing

Status
Not open for further replies.
kevlar49

kevlar49

Materials
Joined
Jun 1, 2006
Messages
287
Location
US
NASM 1352 notes 4 finishing details (cadmium plate, silver flash, etc) for Heat resistant materials. Are all of them applied or does the user specify one of the four?
 
Sort by date Sort by votes
No, all four do not apply. The end user specifies which one to use. I don't have this particular standard right in front of me, but there should be an explanation of how to specify the finish. Usually one of the characters that appears after the dash:

NASM1352-???
 
Upvote 0 Downvote
Thanks TVP. That helps a lot!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

starflex
  • Locked
  • Question Question
Weld finishing with oxy-cut
Replies
8
Views
327
DekDee
DekDee
kevlar49
  • Locked
  • Question Question
mS9490 finishing
Replies
1
Views
97
TVP
TVP
AllAngles
  • Locked
  • Question Question
Finishing Suggestion for AISI 1144 Turned Part
Replies
4
Views
233
mfgenggear
mfgenggear
BMKR
  • Locked
  • Question Question
What does Optical Finishing Temperature Mean?
Replies
12
Views
298
cloa
cloa
leewald
  • Locked
  • Question Question
mirror finishing
Replies
6
Views
171
Ron
Ron

Part and Inventory Search

Sponsor

Back
Top