Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NACE trim PRV set 1440 psi
- Thread starter JAlton
- Start date
If any of the pressure containing parts, or wetted parts necessary for the correct functioning of the valve, are other than carbon or low alloy steel, then it would be any concentration above zero ppm
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
123engr
Chemical
- Dec 10, 2012
- 35
SJones,
I am involve in a produced water project where I need to recommend either Carbon steel or Carbon Steel (NACE) for the service.
I need to know the threshold required to determine whether a NACE material is required or not.
I am what I am by His grace
I am involve in a produced water project where I need to recommend either Carbon steel or Carbon Steel (NACE) for the service.
I need to know the threshold required to determine whether a NACE material is required or not.
I am what I am by His grace
- Status
Similar threads
- Locked
- Question