My part file (in NX) partly disappear when rotating it 3

[StianAndersen]

Hello

I just started to learn Siemens NX and im having a problem. When I make a part and Im rotating it to have a look it partly disappear (the edges). It should not be due to my graphic card, couse its a very good one. I red somewhere I had to go Preferences - Visualization performance - and under "Large model" I should uncheck "Fixed frame rate". This doesn't do the trick for me. Hope anyone can be so kind to help me out here.

[/url]]

Stian

 

[joycejo]

You are rotating beyond the current view extents, fit the model and this will behave as expected

John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6, NX7.5,NX8.5, NX9.0
Vericut7.3

 

[StianAndersen]

Thank you for your fast reply. Can you please tell me where to find where to adjust this? Was looking at Menu - tools - Vehicle Design Automation - Vision model - Direct field of view. But this didn't make me much smarter im afraid is there a specific place to punch in some numbers, or is it a box to check /uncheck?

Again thank you
Stian

 

[cowski]

View -> operation -> fit
Or, if you like keyboard shortcuts:
[kbd]Ctrl[/kbd] + [kbd]F[/kbd]

www.nxjournaling.com

 

[StianAndersen]

Thank you 1000 times! You are the best