Hello,
I need to use multipro command to get some input [below], when I put this in my input file, the following commands are executed and ANSYS does not wait for the user to hit either OK or CANCEL. I tried to use it in a macro but the macro does nothing, even it does not give any error. Any ideas?
TIA
PS: I am using windows xp, ANSYS v110
/prep7
multipro,'start',3
*CSET,1,3,BYW,,5
*CSET,4,6,BYH,,10
*CSET,61,62,'Enter Mesh Control Input'
multipro,'end'
I need to use multipro command to get some input [below], when I put this in my input file, the following commands are executed and ANSYS does not wait for the user to hit either OK or CANCEL. I tried to use it in a macro but the macro does nothing, even it does not give any error. Any ideas?
TIA
PS: I am using windows xp, ANSYS v110
/prep7
multipro,'start',3
*CSET,1,3,BYW,,5
*CSET,4,6,BYH,,10
*CSET,61,62,'Enter Mesh Control Input'
multipro,'end'