Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Multiple rotated cuts using the same axis

Status
Not open for further replies.

Adrian2

Mechanical
Joined
Mar 13, 2002
Messages
303
Location
CA
Dear Folks;

If, during the course of making a 3d model in sw2001-2003 you have to make many rotated cuts using the same axis, can you choose a common axis or do you have to draw a new centerline every time you create a new sketch ?

Kind Regards

Adrian D
 
You can use either a temp Axis, or an Axis you put in yourself as many times as you need to. The axis is not absorbed into the feature, but rather it is it's own feature and can be used numerous times.

Hope that helps, Scott Baugh, CSWP [spin] [americanflag]
3DVision Technologies
credence69@REMOVEhotmail.com

*When in doubt always check the help*
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top