Multiple Parts in a Single Cavity using Moldwizard (NX9)

[Cid1979]

Ok I have a job I am working on that is two cavities and I use Moldwizard to do my jobs in, molding, then shrink, then it goes to parting, where I split it and create the cavity and core blocks, now here is my question how do you do a two cavity in a single cavity block and still have it use the trim function for your ejector pins, I can not figure out how to do it other then using family tool and split the part twice, which I shouldn't have to do. Any Ideas out there would be greatly welcome. I have a generic parting picture attached to show the idea. I know I can find a work around I'm just trying to find the correct way to do this. John Baker any ideas?

 

[marcin0110a]

Hello
We have several ways:
Look at this avi.

https://www.dropbox.com/s/7g3249uyiv6yhst/mold_1.avi?dl=0

This way is good when we have two simple model.
Regards
Marcin

 

[Cid1979]

Thank You Marcin0110a that's a way I haven't tried or even seen yet.

 

[marcin0110a]

I worked several years in Mold Wizard application. I think know more or less everything about moldwizard and configuration. If You have more question, please just ask.
regards
Marcin

 

[Cid1979]

Marcin0110a, You have any custom mold wizard components that you would be willing to share like a cam\slide system? trying to start a library. It would be greatly appreciated.