Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Multi-Threading NXOpen

Thread starter EngProgrammer
Start date Sep 8, 2015

Status: Not open for further replies.

Sep 8, 2015

EngProgrammer

Aerospace

Dear Forum,

Has anyone tried or know how to multi-thread instances of NXOpen geometry creation within the same NX session. I've multi-threaded vb.net applications but haven't tried it with NXOpen geometry creation. GTAC says that it's not possible, because there is only one main thread. Just wondering if someone has tried and has a potential work around.

Thanks